[Elecraft] KPA100 Final Transistor base resistance

[Ron D'Eau Claire]

For some reason the latest Errata hasn't been posted to the web site, but it
should be shipped with the kits (D-4, December 2, 2006). In any case, the
11-16 ohm spec is correct for both Q1 and Q2 base to ground. 

Ron (whose finger slipped on the key that day) AC7AC



-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Darwin, Keith
Sent: Saturday, December 23, 2006 1:10 PM
To: Elecraft at mailman.qth.net
Subject: RE: [Elecraft] KPA100 Final Transistor base resistance


Maybe.  When I did my Rev D KPA100 a few weeks ago, only ONE of the
resistances was changed to read 11 - 16 in the errata.  The other still said
12 - 16.  Maybe the errata has been update in the last few weeks?
 
In my case, both transistors measured 11.5 ohms and the rig works fine.
 
73!
 
- Keith N1AS -
- K2 5411.ssb.100 -

________________________________

From: elecraft-bounces at mailman.qth.net on behalf of Don Wilhelm
Sent: Sat 12/23/2006 12:25 PM
To: Kevin Schmidt; Elecraft at mailman.qth.net
Subject: RE: [Elecraft] KPA100 Final Transistor base resistance



Kevin,

You are OK - check the Rev D manual and its errata sheet and you will find
the range has been changed to 11 to 16 ohms.

73,
Don W3FPR



_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com