[Elecraft] Quick Questtion on KX1 ATU

[Don Wilhelm]

Kieth,

The gap is a little more than 1/16 inch and less than 1/8 inch.  If you
solder the pins so there is just a bit of the square portion sticking beyond
the ATU board surface that should be close enough.

73,
Don W3FPR

> -----Original Message-----
>
> I know it's bad form to reply to your own message, but I think I
> just found my own answer in the Errata sheet.  It sounds like
> that gap is ok to be there....
>
> So now the question is, how big should the gap be so that I can
> get it back?
>
> 73 de Keith KB3ILS
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.15.26/597 - Release Date: 12/21/2006
6:45 PM