[Elecraft] KPA - Hi Curr

[Dohn]

OK ..... Cal Curr is set to 3.5.  I use an MFJ 4125 switching supply.  My
display shows 13.4 volts and 0.45 amps with the ribbon cable connected.

 

Connections are correct at the antenna.

Continuity is good from TP2 to the antenna on all bands.

I get the "Hi Curr" message before the reading on all bands except 10, 12,
15 and 20 meters.  On these bands I DO NOT get the message but the readings
are the same .1 watts and 1.0-1 measurements.

 

Dohn N8EWY  (Frustrated in Tecumseh)