[Elecraft] KPA100 - Q2 resistance check error - Problem?

[Jim Brassell]

Keith,

I measured the same thing on my KPA100 which I finished two weeks ago.  It 
works fine.

73,

Jim, K4ZMV


----- Original Message ----- 
From: "Darwin, Keith" <Keith.Darwin at goodrich.com>
To: <elecraft at mailman.qth.net>
Sent: Saturday, December 02, 2006 8:21 AM
Subject: [Elecraft] KPA100 - Q2 resistance check error - Problem?


I'm building a Rev D KPA100.  During the final resistance checks (p.43) I 
got 11.5 ohms for both Q1 base and Q2 base.  The manual 11-16 ohms for Q1 
and 12-16 ohms for Q2.  So Q1 is OK but Q2 is out of spec?

This resistance table was changed by the eratta.  Before that it said 12-16 
for both transistors.  I'm thinking this is a documentation error and it 
should say 11-16 for both but before I apply power I figured I should check.

- Keith N1AS -
- K2 5411.ssb -

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com