[Elecraft] KPA100 - Q2 resistance check error - Problem?

[Darwin, Keith]

I'm building a Rev D KPA100.  During the final resistance checks (p.43) I got 11.5 ohms for both Q1 base and Q2 base.  The manual 11-16 ohms for Q1 and 12-16 ohms for Q2.  So Q1 is OK but Q2 is out of spec?
 
This resistance table was changed by the eratta.  Before that it said 12-16 for both transistors.  I'm thinking this is a documentation error and it should say 11-16 for both but before I apply power I figured I should check.
 
- Keith N1AS -
- K2 5411.ssb -