[Elecraft] K2, Freq readout

[John [K7SVV]]

Don,
     That may be part of the problem.  I did the CAL FIL and then the CAL
PLL failed.  Since I had just started setting this up I felt I wouldn't lose
much by powering up with 4, 5, and 6 depressed abd haven't gone back to do
it again.  This may be why the frequency doesn't change (no lookup tables).

John   [K7SVV]


On 4/30/06, Don Wilhelm <w3fpr at earthlink.net> wrote:
>
> Carel,
>
> You8 did not specify, so I must ask -- did you alos do CAL FIL before you
> checked the result.  It is necessary that you do both CAL PLL and CAL FIL
> (for each BFO) after adjusting the refcerence oscillator.
>
> 73,
> Don W3FPR
>
> > -----Original Message-----
> >
> > Seems that something strange is going on with my K2 (-:
> > Reading through the responses it strengthened my feeling I did
> > the procedure
> > (as described by Wayne, n6kr getting an exact difference of 10.000 MHz
> > between tp1 and tp2) correct. But my readout is still approx 1 KHz off.
> >
> > Will give it another go (-:
> >
> > 73's,
> > Carel.
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>



--
John   [K7SVV]