[Elecraft] ALC

[W3FPR - Don Wilhelm]

Leigh,

I don't think that applies in this particular case, it is however good
information to pass along for those with a setup like yours.

Phil said he was using the transverter interface for output, and I assume
that means the K60XV output.
The K60XV has its own source for VRFDET, so it would control the input level
to the transverter when the low level output is selected.

73,
Don W3FPR

> -----Original Message-----
>
> On a related subject, ff you have a KAT100 (not likely if you are using
> a transverter) the Vrfdet line from it takes precedence over the KAT2 or
> internal RF detector in the K2 and the power control will make the
> output at the KAT100 match the knob setting on the K2.  This is a
> problem if you have a KAT100 and a non-Elecraft amplifier, so Gary
> suggested I not bring Vrfdet into the K2 from the KAT100 and that fixed
> it for me, so it reads K2 output power again.
>
> Leigh / WA5ZNU
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.10/119 - Release Date: 10/4/2005