[Elecraft] ALC

[Leigh L Klotz, Jr.]

On a related subject, ff you have a KAT100 (not likely if you are using 
a transverter) the Vrfdet line from it takes precedence over the KAT2 or 
internal RF detector in the K2 and the power control will make the 
output at the KAT100 match the knob setting on the K2.  This is a 
problem if you have a KAT100 and a non-Elecraft amplifier, so Gary 
suggested I not bring Vrfdet into the K2 from the KAT100 and that fixed 
it for me, so it reads K2 output power again.

Leigh / WA5ZNU
> Don Wilhelm wrote:
> Phil,
>
> There is no ALC input to the K2, and normally it is not needed.  There 
> is
> ALC internally in the K2 to keep the output level at whatever power is
> selected on the POWER knob.