[Elecraft] K2 Rev E Manual

[W3FPR - Don Wilhelm]

Russ,

Yes, you can use the Rev E manual to build your K2, but ...

I recommend that you build it just like a brand new (current)K2.  That means
you will need to order the PLL Temprature Stability parts and the Keying
Waveshape change parts, 2 1N4148 diodes, and possibly new firmware - check
your firmware level, it the KIOC is version 1.09 and the MCU is version 2.04
you have the latest already.

Download Rev F manual and build according to that manual and you will have a
K2 that is current ship level.  You may have to make one cut on the RF board
at U4 pin 16 to properly install RFC15 - check the A to B instructions page
5 figure 2 to show you where to make this cut. (That is true whether you use
the Rev E or Rev F manual).

If you chose not to upgrade the firmware, you can still install everything
except the Keying Waveshape change - in that case, you would build the
Control Board according to the Rev E manual that you have and everything
else can be built as instructed in the Rev F manual.

73,
Don W3FPR

> -----Original Message-----
>
> After a 2 year delay (starting a business), I'm finally ready to start
> building my K2. It is Rev A kit for which I purchased the Rev B
> upgrade with
> new PC boards. I can't remember why now, but I wound up downloading and
> printing a Rev E manual after buying the upgrade. The instructions say to
> use the Rev D manual to build this version. The archives don't say much
> about Rev E, so my question is: can I use the Rev E manual to
> build my kit
> and is there anything I need to change if I do so?  Thanks in advance for
> your help.
>
> Russ,  W9EL
>
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.9.7/60 - Release Date: 7/28/2005