[Elecraft] KPA100

[Evert Bakker (PA2KW)]

Hello all,

 

Finally after 8 month I'm building the KPA100 module and hope to install
this option next weekend.

But when reading the manual on page 21 it is suggested to cut pin 4 of the
P4 connector (used for the ribbon cable) as to introduce some kind of a key.

Except if you expect to use this pin (8T 8-volt transmit) for any reason. I
can't figure out at this stage if I will need this "signal" for any kind of
homebrew option.

I hate cutting pins and find out next month that I shouldn't have done it.

 

Does anyone know about any kind of modification that might need this 8T
line?

 

Thanks in advance.

 

Evert, PA2KW

 

K2 : sn 4836