[Elecraft] KPA100 K3 relay

[Don Wilhelm]

Trevor,

The reason K3 is no mounted until later is to allow more room for pulling
the wires through T2 and soldering the core and wires - but since you have
it already mounted, I would say that you should leave it in and work around
it carefully rather than risk damage by removing it.  OTOH, if you have a
good desoldering tool like the Hakko 808, removing it would be easier and a
prudent thing to do.

73,
Don W3FPR

> -----Original Message-----

>
> Well, after carefully reading the manual and noting that relay K3
> should not be installed
> until after T2, I lost concentration and installed it by mistake.
> Is this a show stopper,
> requiring removal of the relay, or more to do with having enough
> room to solder T2 to
> the long pads etc?
>
> Trevor  G0KTN
>
>