[Elecraft] KPA100 K3 relay

[Ken K3IU]

Hi Trevor:
I'm reasonably sure that the latter reason is the driving 
force.  From experience in removing T2, the hot iron CAN accidentally 
bump into K3.
Press onward...
73,
Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

At 06:57 AM 12/29/2005, Trevor Smithers wrote:

>Well, after carefully reading the manual and noting that relay K3 
>should not be installed
>until after T2, I lost concentration and installed it by mistake. Is 
>this a show stopper,
>requiring removal of the relay, or more to do with having enough 
>room to solder T2 to
>the long pads etc?
>
>Trevor  G0KTN