[Elecraft] 34472 another KAT2 question

[Mike S]

At 05:47 PM 11/24/2004, jerry wrote...
>Now my other question, on page 12, it says to place the "lock washers between the standoff and the pC board, NOT between the PC baord and screws as on the control board."            ,  BUT on page 6 the diagram has the lock washer between the pc board AND standoff for the control board.
>
>Is this a mistake in the manual , I placed the lockwasher on the L-C board between the board and screw.

Yes, the instructions are ambiguous.

Just do it so no parts get compressed when assembling the two boards together. The spacing instructions are supposed to ensure that there's enough clearance for components (the BNC connectors, AIR). The actual spacing doesn't really matter.