[Elecraft] SSB low output

[Don Brown]

Hi

Just a thought , do you have the microphone attenuator turned on. I think it defaults to on when the K2 is first set up. SSBA should be at 2 and SSBC should be at 1-2 or 1-3. I have fallen into this trap a few times

Don Brown

KD5NDB


  ----- Original Message ----- 
  From: Brian Mury<mailto:ve7ngr at rac.ca> 
  To: elecraft at mailman.qth.net<mailto:elecraft at mailman.qth.net> 
  Sent: Sunday, November 21, 2004 1:37 PM
  Subject: Re: [Elecraft] SSB low output


  On Sun, 2004-21-11 at 19:06 +0000, Geoffrey Mackenzie-Kennedy wrote:
  > Brian, I am using the Heil Proset Plus, without any mods to the K2/100 audio
  > input circuit, and get the full 100 watts on all bands. Is your power supply
  > acting up by any chance?

  Thanks for the suggestion. I think it's ok. I can get full power out in
  any mode, including SSB if I yell or whistle loud enough, or use my
  PK232 to drive it in FSK modes. Current draw looks ok too.

  What element to you have in your Proset Plus?


  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net>
  You must be a subscriber to post to the list.
  Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>    
  Help: http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm>
  Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/>