[Elecraft] PSK31 question

[Charles Greene]

Dan,

Set the power at 6 watts, then adjust the audio drive so you get 5 watts 
output.  You can also watch the ALC, with the ALC/RF on ALC.  It should 
just begin to flicker on the far right hand side.  Press and hold ANT 1/2 
and TUNE to read power forward power/reflected power.  The display should 
read 6.0 F and 0.0r when your antenna it tuned up.  Note that when you 
change audio frequency, you may have to readjust the audio drive because of 
ripples in the OP1 filter bandpass.

73, Chas

At 03:52 PM 11/13/2004, Dan Barker wrote:
>Question about transmitter drive setup.
>
>I'm about to go on the air with the K2 Power knob full clockwise, and the
>soundcard drive (Digipan) set for about 1A draw on key down. Is that right?
>
>Dan / WG4S / K2 #2456 with KPSK2, er, ah KSB2