FW: [Elecraft] K2 Control Board

[Dan Barker]

We all need to say in which manual something is or is not found.

I was searching (with Adobe) "K2 manual rev E.pdf", Don references, and you
were building using, "K2 manual rev F.pdf". The great thing about these
manuals online is that they are vector rather than graphic so the search
works even on schematics and placement diagrams!

Dan / WG4S / K2 #2456

ps: To find R22 on the CB placement diagram, you must search for D3! The
silk-screened label is on the board AND diagram, but the side-tone is far
nicer sounding with D3 gone and R22 (plus a couple other parts) there.

-----Original Message-----
From: W3FPR - Don Wilhelm [mailto:w3fpr at earthlink.net]
Sent: Saturday, November 13, 2004 6:20 PM
To: Dan Barker; Elecraft
Subject: Re: [Elecraft] K2 Control Board


Dan,

Don't throw that resistor away yet!!!  Yes, I agree that Acrobat Reader is
useful for stuff like that, BUT ...

Check the 3rd step on page 15 of your Rev F manual - you will see that R22
82k is placed into the holes marked 'D3'.

73,
Don W3FPR

----- Original Message -----

> No r22 on Control board. there is an rp2 that's 82K.
>
> Viva Acrobat!
>
> Download the PDF and use searches! It rocks!
>