[Elecraft] K2 Control Board Resistance Checks

[W3FPR - Don Wilhelm]

Jeff,

The reading is a wee bit on the low side, BUT...
The proper answer depends on your DMM.  First try reversing the probes, and 
try another DMM if you can obtain one (beg or borrow).

Bottom line - know your test instruments and their limitations - only then 
can you know whether a problem exists or not.

73,
Don W3FPR

----- Original Message ----- 
>
> I have just completed the Control board on #3375 and have a question about
> the resistance checks.  Specifically the check on U4, OUT
>
> The manual says to look for 3-7 k at this pin ... and I measure 2.48 k 
> with
> my DMM.  Is this value close enough?  Should I be looking for a problem to
> correct?
>