[Elecraft] Spectrogram help

[Tom Arntzen]

Dan!
Pick one filter and start playing with the bfo setting in cal fil.
Note the change on spectrogram.
Also change to speaker out on rear of the rig and adjust AF to suitable 
setting.
The speaker output will give you full range on audiospectre.
If you move bfo and it move wrong way?
Simply move it the other way.
But first you must decide what pitch you want on cw and begin from there.
Pick fl2 and decide bandwith.
Put markers in spectrogram.
If you want 700bw on fl2 and pitch 600hz you put one marker 350hz below and 
one marker 350hz higher than 600hz on spectrogram.
Now you adjust bfo until bandnoice is sentered within the two markers.
Repeat with other modes and filters.
Don't forget CW-r and RTTY-r.
I think this will do it for you.
Have a nice weekend Dan.
Tom LA1PHA

----- Original Message ----- 
From: "Dan Schieler" <dschieler at sierrawireless.com>
To: <elecraft at mailman.qth.net>
Sent: Friday, November 05, 2004 8:11 PM
Subject: [Elecraft] Spectrogram help


I must be doing something wrong.  Have my BFO settings exactly as
specified in the K2 manual on CW.  Using the noise gen from Elecraft.
However, during the BFO settings per the K2 manual, FL2-FL4 at the BFO
settings they specify results in almost no audio coming from the speaker
using the N-gen.  Then, when I go to spectrogram, my entire curve for
FL1 is to the right of 600Hz on this display and no matter what I do
with the vfo knob, there is no shifting of the curve to speak of and
just changes in amplitude.  On FL2-FL4, there is no amplitude at all but
I can then adjust the VFO and see/hear the Ngen signals coming thru but
the entire curve is still to the right of 600Hz.  Running spectrogram
off the headphone jack to my sound card.

During operation, my CW mode audio level is considerably below the LSB
or USB level and my receive CW signals seem to turn to clicks at audio
freq below 800Hz or so.....what have I missed?

Thx
K5GUS
Dan



_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): 
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com