[Elecraft] Allignment Part 2. K2 #4270

[Unifiedtx at aol.com]

Allignment, part 2 was going along fine.  Then I tried to tweak C22 and do 
another PLL.  Now I can't get the frequency readings on CAL FCTR, CAL PLL nor 
CAL FIL.  I can get the bandwidth and BFO settings in CAL FIL, but no frequency 
readouts.  I plugged in the frequency counter probe from my other K2, and that 
did not solve the problem.  I did a 456 reset, put the K2 in 40C, FL1 and 
attempted another PLL.  All I got was a string of zeros followed by INFO 232.  
Prior to this glitch ALL parameters in Allignment, part 2 were inside the 
correct tolerences.  Any ideas to get the frequency counter back would be 
appreciated.  Thanks.  Roy Morris  W4WFB