[Elecraft] SSB adjustment

[Bruce D. McLaughlin]

Thanks Don.  I have downloaded the material and I am going to look it
over.  I'm sure it will help a lot.  Thanks for the response.

Bruce - W8FU

-----Original Message-----
From: Don Wilhelm [mailto:w3fpr at isp.com] 
Sent: Wednesday, May 19, 2004 10:13 PM
To: Bruce D. McLaughlin; elecraft at mailman.qth.net
Subject: Re: [Elecraft] SSB adjustment

Bruce,

Take a look at my website www.qsl.net/w3fpr article on K2 dial
calibration -
Step 3 covers the CAL FIL info for both CW and SSB, and has a number of
links to additional information.  I believe it will answer your
questions.
I believe the 'real' key is to align the SSB filters so that the low
frequency -3dB point of the filter bandpass is located at approximately
300
Hz - that seems to work well for the majority of speech frequency
patterns.

If you have additional questions about the content of that article, feel
free to e-mail me at (mycallsign)@arrl.net and I will do my best to
assist.

73,
Don W3FPR

----- Original Message ----- 

> OK.  I've decided to have another go at getting my K2-100 to work
better
> on SSB.  It's about a year old now and it is great on CW - it has
found
> a lot of DX and stateside contacts both at the QRP level, at 100 watts
> and at QRO with an external amp.  But I've not used it very much for
> SSB.  The 2 or 3 times I have, the audio reports have been less than
> enthusiastic.  I haven't been in a great hurry to do this because I
> operate maybe 90 percent CW.
>
>
>
> There is a significant difference in transmitted audio between upper
and
> lower sideband.  I set up SSB using Spectroscope as I did with CW.  CW
> worked fine but SSB setup was not so fine.  So, I'm considering trying
> to tweak by transmitting into a dummy load and listening with another
> receiver while I tweak the BFO settings.
>
>
>
> Is that a reasonable method or is there something more elegant?  Of
> course, I could use the numbers in the owner's manual and I might try
> that.  But I would like suggestions.  I know this has been discussed
> many times in the past but I guess I am a slow learner.
>
>
>
> Bruce - W8FU
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/elecraft
> You must be a subscriber to post.
> Elecraft web page: http://www.elecraft.com
>
>





__________________________________________________________
This message was scanned by GatewayDefender
10:11:16 PM ET - 5/19/2004