[Elecraft] Freq error

[Don Wilhelm]

Stan,

You will be able to do steps to achieve better dial calibration after you
have completed your K2, so don't be concerned about it at the Stage II
level.

If you would like more information on Dial Calibration and setting the K2
filter/BFO relationships than is in the manual, check the K2 Dial
Calibration article at my website www.qsl.net/w3fpr

73,
Don W3FPR

----- Original Message ----- 

> I completed stage II alignment and am sitting here listening to the
> K2 on 40 meters (LSB). I notice that the freq. display is showing 650 Hz
> higher than it should. Everything checked out and all voltages and
> frequencies were well within spec, right where they should be. So why
would
> the display want to read 650 Hz high? It almost makes me think it has
> something to do with the CW tone offset.
>