[Elecraft] KPA100 Shield Mod

[Vic Rosenthal]

Don Wilhelm wrote:

> When the KDSP2 is installed, the KPA100 is supposed to be moved slightly to
> the rear to release the pad for the DSP daughterboard.  If the shield clips
> installed, that movement is likely to bend the clips (and if it doesn't, the
> clips may not be making adequate contact with the side panels).

Since my scientific examination of the situation indicates that it would 
take aproximately 139.78 G's to dislodge the DSP daughterboard, I 
removed the little rubber strip alledgedly needed to keep it from 
falling out, thus allowing me to pull the KPA100 straight up.

-- 
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco