[Elecraft] Sooner or later?

[Lou Roux]

Ron,

Well, there may well have been a change to the manual, mine is Rev B. 
Either way, yours is definitely a better way to do it.   :o)

Lou - W6UR



Ron D'Eau Claire wrote:

>I didn't remove the heat sink. IIRC, the instructions suggested simply
>pulling the side panel to get access to the connector locations along the
>edge of the PC board. That's how I did it. 
>
>Maybe that's an "improvement" that's been added to the original manual, or
>me "improvising" again... 
>
>Ron AC7AC
>
>-----Original Message-----
>...I would, however, order and 
>install RF-P3 and RF-P6 (part # E620012). This way you won't have to 
>remove the heat sink from the K2 to install them later.
>
>Lou - W6UR
>
>
>
>
>_______________________________________________
>Elecraft mailing list: Elecraft@mailman.qth.net
>You must be subscribed to post to the list.
>To subscribe or unsubscribe see: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com
>Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
>
>  
>