[Elecraft] Sooner or later?

[Ron D'Eau Claire]

I didn't remove the heat sink. IIRC, the instructions suggested simply
pulling the side panel to get access to the connector locations along the
edge of the PC board. That's how I did it. 

Maybe that's an "improvement" that's been added to the original manual, or
me "improvising" again... 

Ron AC7AC

-----Original Message-----
...I would, however, order and 
install RF-P3 and RF-P6 (part # E620012). This way you won't have to 
remove the heat sink from the K2 to install them later.

Lou - W6UR