[Elecraft] L1 & L2 Alignment Problem

[Carl J. Denbow]

Yes, it tuned up on receive just fine.  I'll check the other things you suggest.  Thanks.

73,

Carl

-- Carl J. Denbow, n8vz at qth.com on 6/2/2004


On Wed, 2 Jun 2004 00:42:13 -0500, k4zm wrote:
> Carl:
>
> Did it tune up ok on receive when you finished stage II?  My first
> place to look would be in the drive train in the Low Pass Filter
> area and make sure you have a good solder connection to L25 and
> L26. (Measure the resistance from the center conductor of the rf
> out coax connector to W1  It should read a very low resistance if
> L25 & L26 are soldered properly.)  Then check and make sure Diodes
> D1-D7 are installed correctly.  Also make sure that C6 is installed
> in the correct holes of J15 and that the correct values are
> installed in the band pass filter assy 40/60 meter area. (C4 - C8)
> It is very easy to install a 82pf instead of the 820pf that is
> called for in the manual at C4 and C8. Also make sure all pins have
> been soldered on relay K1 and K12.
>
> 73
> Jim Younce K4ZM
> K2  SN: 18