[Elecraft] RE: Tuning rates

[David Walker]

You are right Don.  However, this did not happen with my radio before.  But
if I fine tune to XXXX.33 and tune to another frequency using the 1khz
tuning rate and have a look at my fine tune frequency.... the XXXX.33 holds.
This did not happen with my K2 when it wasn't calibrated properly.



----- Original Message ----- 
From: "Don Wilhelm" <w3fpr at isp.com>
To: "David Walker" <vk2icq at dodo.com.au>; "Elecraft reflector"
<elecraft at mailman.qth.net>
Sent: Monday, July 05, 2004 11:14 PM
Subject: Re: [Elecraft] Tuning Rates and fine tune shift.


> Dave,
>
> >From my observations, if the lower order digits on the frequency display
are
> different than xxxx.00 when you switch to 1kHz tuning steps, those
> undisplayed digits will stay the same as they were. - in other words, if
you
> were tuned to 7070.35 and go to the 1 kHz tuning the steps will be to
> 7071.35, 7072.35 etc.
>
> Perhaps Wayne will chime in here with the 'real' answer.  I never paid a
lot
> of attention to it and just assumed it was like I said above.
>
> 73,
> Don W3FPR