[Elecraft] Tuning Rates and fine tune shift.

[G3VVT at aol.com]

Rich,
 
Missed that cause somehow when trying to find the reason for the 50Hz  shift.
 
Can confirm that if in the 100Hz step position it is possible to slightly  
move the VFO without changing the display on that RATE selection, though does  
show up as a 50Hz shift when the 10Hz RATE selection is made. If a normal  
shift of the VFO is made on the "100Hz" step selection to a desired  frequency, it 
is a matter of luck where the last 10Hz digit can end up.  Most times it 
seemed to end up unchanged when tried originally.
 
The question will no doubt come up again in the future.
 
Bob, G3VVT
K2 #4168