[Elecraft] No shift from VFO A to VFO B?

[Brien Pepperdine]

Members -
this past weekend was in part spent happily getting acquainted with my new 
to me gently-pre-owned K2. What a wonderful radio.
People are still intrigued by the K2 when mentioned in qsos and it seems 
many are thinking seriously about getting one - the vibe on them is so good!
(Eric and Wayne et al are saying: "So they should go ahead and GET one!")

One small possible glitch I think I encountered was that the VFO button 
when tapped does not take me from VFO A to VFO B. It just stays on A. Nor 
does the button, when in HOLD, go to VFO REVerse (probably not surprising 
given the lack of the second vfo to show up...)

Seems to me the button simply does not work, probably. Bad switch or a 
solder joint I think?

I doubt there is any chance this is a firmware issue all.
(unless I missed somewhere in the manual wherein you are allowed to lock 
the VFO to one vfo only...)

Anyhow I thought I would ask - it would be this weekend at least or more 
before I could disassemble and check the switch solder connections with the 
soldering iron/continuity tester and even I did so I'd probably get a new 
switch on hand just in case so as to not have to go invasive again.
In any case it is a minor issue to me since I rarely if ever work split nor 
do I have to set one versus another for any favourite frequencies.

tnx

Brien Pepperdine
Toronto