[Elecraft] How I make My PC Boards

Fri Jan 16 14:54:01 2004

Tom,

Just finished reading your PCB Howto.. Very nice.. Thanks for taking the 
time to write it down.

Denis - KC6AUP

On Wed, 14 Jan 2004, Tom Hammond wrote:

> Over the past couple years, I have received a number of requests from 
> builders asking for information regarding how I make my PC boards using the 
> photo-etch process.
> 
> I have now produced a document which outlines the basic steps I take when 
> making my PC boards. It is NOT a "How-To" article... that would be much too 
> lengthy, but it will (hopefully) give you ample information to decide 
> whether the process I use is one which you might want to investigate 
> further. While the process I use does produce some pretty nice looking PC 
> boards, it does NOT approach 'commercial quality', that type of product is 
> left to those with a LOT of resources.
> 
> Anyway, the document is available at:
> 
>    www.qsl.net/n0ss
> 
> under the general heading of "Files Related to Building".
> 
> I hope those of you who download this document find it helpful.
> 
> 73,
> 
> Tom   N0SS
> 
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
> 