[Elecraft] K2 Frequency calibration

[Tom Hammond]

>>>I can get them (or at least the ends to make them) from the Mfg?
>>
>>You certainly can.
>>
>>Assuming your K2 is NOT one of the very first 300-400 units sold
>>(which used a different type of TP jack, you'll need to order the
>>following parts:
>>
>>          Elecraft
>>   Quan   Part No.  Description
>>
>>     1    E530067   10pf cap Axial Leads
>>     1    E620044   1-pin male probe tip
>>     1    E620021   2 pin female housing
>>     3    E620022   female crimp pins
>>     1   E980028   4" heat shrink, 3/16" dia.
>>     1    E760010   3' RG-174 Coax Cable
>>
>>The 3rd female pin is a backup in case you botch one. And there's
>>a LOT more RG-174 than needed if they actually send you 3 FEET.
>
>Actually the third pin is for the voltmeter probe.  For that probe, he'll 
>also need a second 2 pin female housing and some hookup wire.

Actually that's why Elecraft shows three... but _I_ suggested gettin gthe 
3rd one just as a backup in case one of them gets botched during assembly. 
They're kinda 'tender', and difficult to repair if damaged, and the added 
cost of an extra far outweighs having to order a spare (replacement) later.

Tom    N0SS