[Elecraft] K2 power anomalies

[Vic Rosenthal]

Julian, G4ILO wrote:

> It appears that the K2 takes no notice of the Po28 option set in the 
> seconadry menu. Although the numbers in the display stop increasing when 
> they reach the value set when you rotate the knob on the front panel, the 
> actual power out is the same whether this option is selected or not. With 
> the control fully clockwise the power out from my K2 is typically 11.9W as 
> reported by the KAT2 in CalP mode, regardless of the Po28 setting.

As I understand it, the Po28 option ONLY applies to SSB mode.

-- 
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco