[Elecraft] KAT2 Toroids Installation

[Don Wilhelm]

Paul,

You understand the instructions correctly, but leave yourself just a little
bit more slack in the wires and you will have no trouble rotating the toroid
up to about a 45 degree angle and slip the insulator under it.  When you lay
the toroid back down it will be tight enough to stay.

73,
Don W3FPR

----- Original Message ----- .
>
> As I understand the instructions, I have to make
> the toroid, solder it to the square pads on the
> same side of the board that the toroid sits, lift
> up the toroid (after the leads have been
> soldered), insert the insulator. and then lay the
> toroid back down.
>