[Elecraft] LCR Meter

Mon Feb 23 14:17:00 2004

I'm surprised that no one has mentioned using an antenna analyzer to make
these measurements. I have an Autek VA1, and it can make resistance,
inductance and capacitance measurements at any frequency up to 35 MHz.
Plus, I get to use it on my antennas, too!

73!

Dan KB6NU
---------------------------------------------------------------------------
President, ARROW Comm. Assn. (www.w8pgw.org)
CW Geek (FISTS #9342)
Ham radio bookseller (www.QTB.Com/hamradio/)
Read my ham radio blog at www.blurty.com/~kb6nu .

----- Original Message -----
From: "Bob Tellefsen" <[email protected]>
To: "bill linn" <[email protected]>; "Elecraft Reflector"
<[email protected]>
Sent: Monday, February 23, 2004 2:12 PM
Subject: Re: [Elecraft] LCR Meter

> Bill
> I suggest you check the specs on the B&K unit.
> Most of the LCR units I've looked at over the years
> measure at frequencies under around 20 kHz.  Nowhere
> near adequate for RF component measurements.
>
> The AADE LC II/B work at around 1 MHz, which is
> better, at least.
>
> 73, Bob N6WG
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
>