[Elecraft] No transmit on ssb on my K2

[Don Wilhelm]

John,

The first thing I would check is the power to the amplified mic.  If you are
using the K2's 5 volt supply, you should be able to check it from the front
side of the mic connector (nothing to disassemble).

Next, I'd make certain nothing has come loose on your mic header.  The front
panel assembly is easy to remove (6 screws) unless you have the KAF2 or
KDSP2 installed.

73,
Don W3FPR

----- Original Message ----- 

> Well, it was bound to happen sooner or later (because of me, not my K2) I
> put an amplified D104 on my K2 and made several ssb QSOs over the last
> couple of days. Power settings between 10 and 15 watts. I got very good
> audio reports from all. Today on 2 meters a friend needed to check out his
> mic on 80m and I meet him there, heard him calling me, but when I went
back
> to him, the receive dropped but no power out. I checked everything I could
> think of but have not been able to get it going again.
>