[Elecraft] K2 control Board Resistance Checks

[W3FPR - Don Wilhelm]

Chuck,

Try reversing your DMM probes - it is possible that no real problem exists. 
(the 8T and 8R lines are not used on the Control Board, so the resistance 
checks should indicate only that nothing is shorted - the fact that you show 
similar reading on both lines - and both show some resistance - cause me to 
suspect your DMM)

73,
Don W3FPR

----- Original Message ----- 
> Control Board.  All but two of the resistance checks appeared okay. 
> However
> the Q1 Collector and Q2 Collector read 3.5K and 4.5K respectively.  The K2
> manual states that I should read a value greater than 1M.  I will go back
> and check for solder bridges etc. again.  Any recommendations on what else
> that I might check during this assembly stage would be greatly appreciated
>