[Elecraft] K2 control Board Resistance Checks

[Chuck Gehring]

I just finished the assembly and resistance checks (IAW page 21) on my K2
Control Board.  All but two of the resistance checks appeared okay.  However
the Q1 Collector and Q2 Collector read 3.5K and 4.5K respectively.  The K2
manual states that I should read a value greater than 1M.  I will go back
and check for solder bridges etc. again.  Any recommendations on what else
that I might check during this assembly stage would be greatly appreciated

73, KI4DGH

Chuck Gehring