[Elecraft] KX1 KXB30 Alignment

[Tony Morgan]

Thanks for the reply.
When I got up this morning and looked at the KX1, I knew I had a senior
moment last night!
I was looking a de-soldering the pins instead of lifting it out.
What do I know, I just built it!

Thanks,

Tony W7GO
----- Original Message ----- 
From: "David Toepfer" <davetoepfer at yahoo.com>
To: "Tony Morgan" <w7go at earthlink.net>; "#elecraft"
<elecraft at mailman.qth.net>
Sent: Thursday, August 12, 2004 1:02 AM
Subject: Re: [Elecraft] KX1 KXB30 Alignment


> Simply remove your kxat1, re-jumper pins 1 and 3 of j7 near the antenna
jack,
> and follow the Receiver Alignment procedure outlined on p45 of your kx1
manual.
>  Then when this is doen, re-install your kxat1.
>
> kb3ipe
>
> dt
> .
>
> --- Tony Morgan <w7go at earthlink.net> wrote:
>
> > Hi Guys,
> > Have almost completed KX1 #770.
> > Everything is fine so far. My question is with the KXAT1 installed, how
do I
> > get to trimmer 20A on the KX1 board?
> > In the KXB30 manual, page 7, last step it says to re-align rcvr on 20
mtrs.
> >
> > Thanks,
> >
> > Tony W7GO
> >
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.):
> > http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com
> >
>