[Elecraft] KX1 KXB30 Alignment

[David Toepfer]

Simply remove your kxat1, re-jumper pins 1 and 3 of j7 near the antenna jack,
and follow the Receiver Alignment procedure outlined on p45 of your kx1 manual.
 Then when this is doen, re-install your kxat1.

kb3ipe

dt
.

--- Tony Morgan <w7go at earthlink.net> wrote:

> Hi Guys,
> Have almost completed KX1 #770.
> Everything is fine so far. My question is with the KXAT1 installed, how do I
> get to trimmer 20A on the KX1 board?
> In the KXB30 manual, page 7, last step it says to re-align rcvr on 20 mtrs.
> 
> Thanks,
> 
> Tony W7GO
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>