[Elecraft] K2 Spot causes signal distortion

[Tom Arntzen]

Does it help to lower level of spot tone?
I use spot often on my K2 3829 and no distortion heard , but I have never
run it on high levels?
I adjust level on spot so an incoming signal blanks it out when pitch is
near optimal center.
Tom LA1PHA
How is your transmitted signal?
Any stray from PS?

----- Original Message ----- 
From: "Jay Blass" <jayblass at comcast.net>
To: <Elecraft at mailman.qth.net>
Sent: Wednesday, August 04, 2004 9:59 PM
Subject: [Elecraft] K2 Spot causes signal distortion


Just getting K2 4329 aligned and on the air.

All alignments are complete (thanks to spectrogram and Tom Hammond), but I
have found that activating the spot tone feature distorts the incoming rx
signal. This is very evident both auditory and when viewing the signal on
Spectrogram.

I've used Spotting on the K1 extensively, but the current situation on the
K2 makes this feature unusable.

Any ideas?

Jay
N5ACM
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com