[Elecraft] K2 Spot causes signal distortion

[Hisashi T Fujinaka]

Make sure you didn't break RFC15 (check for continuity). You'll also
hear a very ugly sounding transmit signal if RFC15 is broken.

On Wed, 4 Aug 2004, Jay Blass wrote:

> Just getting K2 4329 aligned and on the air.
>
> All alignments are complete (thanks to spectrogram and Tom Hammond), but I have found that activating the spot tone feature distorts the incoming rx signal. This is very evident both auditory and when viewing the signal on Spectrogram.
>
> I've used Spotting on the K1 extensively, but the current situation on the K2 makes this feature unusable.
>
> Any ideas?
>
> Jay
> N5ACM
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>

-- 
Hisashi T Fujinaka - htodd at twofifty.com
BSEE(6/86) + BSChem(3/95) + BAEnglish(8/95) + MSCS(8/03) + $2.50 = latte