[Elecraft] Notes to new K2 builders - Part 4

[Ken Wagner]

Bill Tippett wrote:

> 3.  Page 70.  Box 3 says regarding Q7 "Do not solder yet."  Unless I 
> missed it, there are never any instructions to solder Q7 and Q8 before 
> Alignment and Test.  I soldered mine from the top side of the board 
> after securing them on the bottom  of the heat sink.  Suggest adding 
> soldering instructions after Box 5 on page 73.

Three steps after your citation it says..."Once Q7 and its hardware 
appears tobe parallel to the PC board as shown in Figure 6-31, solder Q7 
to the top of the board."

73,
Kenb K3IU