[Elecraft] KPA100 question

[Greg Fischer]

Almost finished with my kpa-100, but have a question before proceeding.

When using a LARGE hi thermal mass iron, normally used for pl259 connectors,
solder melted between the two emitters of Q1 and Q2, the emitters that face
each other and between R38 and R39.  I tried to clean it up with solder wick
but still have continuity between the the two, and in fact have continuity
between ALL tabs of Q1 and Q2.

Looking at the schematic, this seem OK, but want to be sure.

Thanks
Greg
AB7R