[Elecraft] How to position the electet in MH2 ?

[Roland]

Hello Elecrafters,

This evening I looked insite my MH2 mic, because I have to shout very =
hard will I put out more than 5 wattt (seen by pep monitor). Even when I =
set the K2 pwr-level to 15 watt. Only when I whistle it will take the =
full watt setting. Mostly often it is not more than 5 watt when I speak. =
Ofcourse I've set the mic gain to 3 and compression to 2-1 or 3-1, less =
difference in output.

Insite the MH2 mic is the electet and some foam.
The electet was on its side with the "input" to the foam in a corner of =
its case.=20
So you can say I was talking to the back of the electet when I speak in =
the upper side of the MH2 mic.

Is the foam for mechanical or to lower the sound?
And what is the right position for the electet, into the foam and =
straight in the case, or on its side and with its back to the upper side =
of the MH2 case. I don't know how to put it back anymore.=20

Is there someone who experienced with this foam and the right position =
of the electet ?
What will happen with the sound quality when I speak direct to the =
electet (not tested yet) ?
Many thanks.=20

73 de PE1PHU, Roland.
---
K2#3195.


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---