[Elecraft] Problem with CAL PLL for 160 meters / INFO 232

Wed Sep 10 14:46:04 2003

Just got done building a 160RX option and mine (at least) did include an
errata sheet that addressed this.

Scott
AG4KU

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Don Wilhelm
Sent: Wednesday, September 10, 2003 2:31 PM
To: zu; [email protected]
Subject: Re: [Elecraft] Problem with CAL PLL for 160 meters / INFO 232

Ueli,

The 'fix' is easy - just run CAL PLL on 40 meters.
You no longer need to run CAL PLL on 160 meters.  Run CAL PLL on 40 meters
instead.
I know the 160 meter manual still has instructions for running it on 160,
but that was written before the firmware version 2 came out.  Perhaps an
errata sheet should be included with the 160 meter option, but apparently
that has not been done yet - the folks at Elecraft have been busy with other
goodies lately.

73,
Don W3FPR

----- Original Message -----

| I have a problem with the VCO linearisation during 160m alignement of K2
(No
| 3680)
| The CAL PLL does not start but shows INFO 232 even though the 7 MHz
| linearisation works fine.

_______________________________________________
Elecraft mailing list: [email protected]
You must be subscribed to post to the list.
To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm