[Elecraft] Torroid question

Mon Sep 1 15:32:01 2003

Greg,
T6 has both sets of windings in series, so your readings would be correct.
John n1sjz

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Greg Fischer
> Sent: Monday, September 01, 2003 3:11 PM
> To: [email protected]
> Subject: [Elecraft] Torroid question
>
>
> Thanks to all the help from this board, things are progressing well... I
> hope.
>
> I do have a question on torroid T6, the bifilar one.
>
> I was extremely careful when tinning the legs so as not to have
> any shorts.
> The enamel for each goes right to the board.
>
> Soldered in with no problems at all.  But here is where I am
> confused.  When
> I test the red and green pads on the bottom of the board, I show
> continuity
> between the red and green pad on the bottom and the same between
> the two on
> the top.  There are no solder bridges at all and the wires do not short on
> the torroid anywhere.
>
> It doesn't matter what combination I try between all 4 pads, I still show
> continuity.
>
> Is this supposed to be like this?
>
> Tnx
> Greg
> AB7R
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm