[Elecraft] Torroid question

[Greg Fischer]

Thanks to all the help from this board, things are progressing well... I
hope.

I do have a question on torroid T6, the bifilar one.

I was extremely careful when tinning the legs so as not to have any shorts.
The enamel for each goes right to the board.

Soldered in with no problems at all.  But here is where I am confused.  When
I test the red and green pads on the bottom of the board, I show continuity
between the red and green pad on the bottom and the same between the two on
the top.  There are no solder bridges at all and the wires do not short on
the torroid anywhere.

It doesn't matter what combination I try between all 4 pads, I still show
continuity.

Is this supposed to be like this?

Tnx
Greg
AB7R