[Elecraft] XV 222

Wed Oct 22 00:04:00 2003

Hi, Carl:

That's L4A, which is an open-frame inductor with a red plastic frame. =
(See
the picture in the parts list at the top of page 23 of the manual)=20

The outline position for the inductor is shown on the parts layout, =
appendix
A, page 4. Find X1, the crystal, inside the circle. The circle should =
appear
on the board. In the image on Appendix A page 4, L4A mounts near the =
left
side of the circle.=20

I haven't seen the latest versions of the XV222 board silk-screening. I
wrote the manual based on building an XV144, and leaned on the Field =
Testers
for comments about the XV222.  Let me know if the outline for X4A is =
missing
on yours. In any case, the appropriate solder pads should be there. X4A =
is a
simple variable inductor with two terminals (it's in the emitter of the
local oscillator on the schematic).=20

Ron AC7AC

-----Original Message-----
From: [email protected] =
[mailto:[email protected]]
On Behalf Of Calvin Starr
Sent: Tuesday, October 21, 2003 8:12 PM
To: [email protected]
Subject: [Elecraft] XV 222

I am building an XV222 transverter and have gotten to page 49.  There is =
a
red inductor to be mounted at Z6 which I can not find on the board.  =
This is
supposed to be near the crystal Y1.=20
Has anyone had this problem or did you find the location for Z6?

Thanks
Calvin KR5E
_______________________________________________
Elecraft mailing list: [email protected]
You must be subscribed to post to the list.
To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm