[Elecraft] SSB Unit and P1

[Paul Clay]

The erratta to the KSB2 manual states that, if you 
have the Elecraft-Heil microphone, you're 
supposed to follow the directions that come with 
the mic.  The instructions that come with the 
microphone just have you jumper all the pins  on 
the control board with the two-pin jumpers that 
come in a brown envelope with the mic.  No messy 
soldering involved; it's simply  "plug and play"!

Enjoy your SSB'ing,
- Paul, N6LQ

On Sunday 19 October 2003 12:47, Tom Mc wrote:
> Hi all,
>   Well as a NY Jets fan I've found myself with a 
lot of time on my hands on
> Sunday's.  I'm moving along with the KSB2 SSB 
adapter.  I've gotten to the
> point where P1 is to be installed.  P1 is used 
to match the K2's inputs and
> outputs to the mic you will be using.
> 
> Basically the manual says (if I'm reading it 
correctly) that you should
> simply wire the posts on P1 to each other.  I 
was hoping someone could tell
> me if I have this right as it would seem that 
this would be somewhat sloppy
> (particularly the way I do things) and 
susceptible to shorts.
> 
> The manual does suggest using two pin shorting 
posts , like those used in
> computers (don't have any of those though).  
This would work in my case
> because I'm using the Heil mic which Elecraft 
sells and the posts for the
> Heil mic all are next to each other.  I'm not 
sure that it would be as easy
> for other mics, though.
> 
> So if you could let me know if I have this 
right, and if you have any
> alternative ideas, I'd appreciate hearing from 
you.
> 
> Tnx
> Tom McCulloch, WB2QDG
> 
> k2 s/n 1103
> 
> 
> 
> 
> _______________________________________________
> Elecraft mailing list: Elecraft@mailman.qth.net
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see: 
http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: 
http://www.elecraft.com/elecraft_list_guidelines.htm
>