[Elecraft] Question #2 on the K2 Build

[Mike Zabel]

Hi Michael,
I'm a newbie here, so maybe others will weigh in here too, but, I just
completed the control and front panel boards on K2 # 3765.
I soldered jumpers on the bottom of the board at R18 and R19. It's my
understanding that I will remove these later when I install the
connector for the KDSP2 (or the KAF2 if I were installing that option)
The other resistors on the bottom of the control board are installed at
R11 and R12.  All my initial resistance checks came out OK but I haven't
made it to Alignment and Test Part 1 yet. 
Good luck and have fun!

73 de Mike kc5uoj

K2 #3765 ---> Starting the RF Board --->