[Elecraft] Question #2 on the K2 Build

Michael D. Heit KD7YLA [email protected]
Tue Oct 7 19:57:05 2003


I am building the control board of my K2 [#3776] and at the step 
concerning the resistors R18 & R19 mounted on the bottom side of the 
board: The manual calls for jumper wires to be mounted on the top of the 
PCB, at the points where R18 & R19 are located. Then it says to mount 
resistors R18 & R19 to the bottom of the board in their respective 
locations... which is where the jumpers come thru the board... seems 
that the jumpers just canceled out the resistors, what am I not seeing 
here?
I do not quite understand what the manual is telling me to do ... I 
think maybe the jumpers need to go some where else than the holes where 
the resistors would go thru???  or are the resistors soldered to the 
jumpers that were placed thru the holes??? This seems confusing at this 
step ...
73, Mike KD7YLA

-- 
Michael Heit KD7YLA

"You have never lived, till you have almost died. And for those who fight for it, life has a flavor that the protected will never know." Penned on a sign at a command post at Khe Sanh, RVN 1968

 "We can't be so fixated on our desire to preserve the rights of ordinary Americans...", Pres Bill Clinton, USA Today, Mar 11, '93, Pg 2A.

 "American Communists worked energetically and tirelessly to lay the foundations for the United Nations which we were sure would come into existence", Earl Browder, Gen Sec, Communist Party-USA.

And the freakin liberals wonder why I distrust the government so dam much!!


---
[This E-mail scanned for viruses by Declude Virus]